Chevrolet Pontiac Wave 2007 Owner's Manual page 200

The CD player can play the smaller 3 inch (8 cm)
single CDs with an adapter ring. Full-size CDs
and the smaller CDs are loaded in the same
manner.
If playing a CD-R, the sound quality may be
reduced due to CD-R quality, the method of
recording, the quality of the music that has been
recorded, and the way the CD-R has been
handled. There may be an increase in skipping,
difficulty in finding tracks, and/or difficulty in loading
and ejecting. If these problems occur, check the
bottom surface of the CD. If the surface of the CD
is damaged, such as cracked, broken, or
scratched, the CD will not play properly. If the
surface of the CD is soiled, see Care of Your CDs
on page 220 for more information.
If there is no apparent damage, try a known
good CD.
Do not add any label to a CD, it could get caught
in the CD player. If a CD is recorded on a
personal computer and a description label is
needed, try labeling the top of the recorded CD
with a marking pen.
200
Notice: If you add any label to a CD, insert
more than one CD into the slot at a time,
or attempt to play scratched or damaged CDs,
you could damage the CD player. When
using the CD player, use only CDs in good
condition without any label, load one CD at a
time, and keep the CD player and the loading
slot free of foreign materials, liquids, and
debris.
If an error appears on the display, see "CD
Messages" later in this section.
2 RPT (Repeat): Press this button to repeat the
current track. RPT appears on the display.
Press this button again to turn off repeat play.
3 RDM (Random): Press this button to hear the
tracks in random, rather than sequential, order.
RDM appears on the display. Press this button
again to turn off random play.
4 INT (Scan): Press this button to listen to the
first few seconds of each track on each loaded CD.
INTRO appears on the display. To stop scanning
press this button again. The current track
begins to play.