Resetting Your Network Settings; Updating The Software; Information On Data Protection - Siemens WD4HU540ES Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Home Connect
en
Notes
If you connect to your home network,
Wi-Fi is activated automatically.
If Wi-Fi is activated, the appliance will
not switch itself off automatically.
If Wi-Fi is switched off on the
appliance, it is not possible to use
the Home Connect app to start or
control the appliance remotely.
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this
connection will be re-established
automatically when Wi-Fi is switched
back on.
If you activate this function, the
energy consumption increases in
comparison to the values specified
in the consumption value table.
Resetting your network
settings
You can reset all of the network
settings.
Ensure that you are in the Home
Connect menu. ~ Page 41
Set the programme to position 5.
1.
§"† (reset network settings)
appears in the display.
Press I.
2.
¢"à appears in the display.
Press I.
3.
If you want to operate your
Note:
appliance via the Home Connect app
again, you will need to reconnect it to
your home network and to the
Home Connect app.
44

Updating the software

You can update the Home Connect
software on your appliance. As soon as
a new software update is available, a
note appears in the display: ž˜š
Install the update directly via the
message in the display or manually as
follows:
Ensure that you are in the Home
Connect menu. ~ Page 41
Set the programme to position 6.
1.
—˜š (software update) appears in
the display. I flashes if a software
update is available.
Press I.
2.
¢"à appears in the display.
Press I.
3.
The software update may take
Note:
several minutes. Do not switch the
appliance off while updates are being
installed.

Information on data protection

When your appliance is connected for
the first time to a Wi-Fi network, which is
connected to the Internet, your
appliance transmits the following
categories of data to the Home Connect
server (initial registration):
Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
installed Wi-Fi communication
module).

Advertisement

Table of Contents
loading

Table of Contents