Sony WEGA KLV-20SR3 Operating Instructions Manual page 41

Problem
Stripe noise during playback/recording
of a VCR.
Poor or no picture (screen is dark), but
good sound.
Noisy picture when viewing a TV
channel.
Distorted picture when changing
programmes or selecting teletext.
Cannot operate the menu
Wrong characters appear when viewing
teletext
No sound/Noisy sound
Good picture, no sound.
Audio noise.
Unable to receive a stereo or dual sound
broadcast
Possible solution
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the TV set to avoid
noise.
• Avoid installing your VCR in front or at the side of the TV set.
• Using the menu system, select the "Picture Adjustment" menu and
select "Reset" to return to the factory settings (page 26).
• Using the menu system, select the "Manual Programme Preset"
option in the "Set Up" menu and adjust Fine Tuning (AFT) to
obtain better picture reception (page 33).
• Using the menu system, set the "Noise Reduction" option in the
"Picture Adjustment" menu to reduce the noise in the picture (page
26).
• Turn off any equipment connected to the Scart connector on the rear
of the TV set.
• If the item you want to select appears in a pale colour is because you
cannot select it.
• Using the menu system, enter the "Country" option in the "Set Up"
menu and select the country in which you operate the TV set (page
30).
• Press the 2 +/- or (mute) on the remote control.
%
• Check that "TV Speakers" option is set to "On" in the "Features"
menu (page 29).
• Make sure that the aerial is connected.
• Keep the aerial cable away from other connecting cables.
• Do not use 300-ohm twin lead cables as interference may occur.
• Communication problems may occur if the infrared communication
equipment (e.g. infrared cordless headphones) is used near the TV.
Please use headphones other than infrared cordless headphones,
move the infrared transceiver away from the TV until the noise is
eliminated, or move the transmitter and receiver of the infrared
communication equipment closer together.
• Using the menu system, select "Audio Filter" from the "Manual
Programme Preset" menu. Next select "Low" or "High" (see page
33).
• Check that the "Audio Filter" option in the "Manual Programme
Preset" menu is set to "Off".(see page 33).
continued...
Additional Information
GB
41