3.5-Inch Hard Drive - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual

Steps
1. Align the slots on the hard drive with the mounting points on the hard-drive carrier.
2. Pry the hard-drive carrier to align the mounting points on the hard-drive carrier with the slots on the hard drive.
3. Snap the hard drive onto the hard-drive carrier.
4. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive
cage.
5. Connect the data and power cables to the connectors on the hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in

3.5-inch hard drive

Removing the 3.5-inch hard drive
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the 3.5-inch hard-drive assembly and provide a visual representation of the
removal procedure.
46 Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.