Remove The Lcd Unit - Lenovo Flex 7i Hardware Maintenance Manual

Figure 29. Remove two screws
Screw specifications
M1.2 x L1.7
Step 4. Remove the touchpad.
Figure 30. Remove the touchpad
Go to https://support.lenovo.com/partslookup
part:
Touchpad

Remove the LCD unit

Make sure the following FRU (CRU) has been removed.
"Remove the lower case" on page 28
"Remove the heat sink" on page 32
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove the four pieces of tape.
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
43