Table of Contents
Advertisement
Auto Installation
Auto Installation System (AIS)
Your television set is provided with an Automatic Installation System which
makes Installation easier.
This new system is activated when you turn on the TV for the first time.
Note:
You may not have to follow this procedure if it has already been
done for you at the establishment where you purchased your TV. If
this is the case, go on to the section entitled -Switching ON-
(page 13).
Procedure:
1.
Put batteries into the remote control, as shown on page 3.
2.
Connect the aerial jack into the aerial input terminal on the rear
side of your TV, as shown on page 6.
3.
Connect the TV power cable to a 220 ~ 240 V system, as shown
on page 10.
4.
Press the main power button (®), on the front of the TV set, to start
the "AUTO INSTALLATION". The orange power indicator will light..
5.
The «AUTO INSTALLATION» menu will appear on your TV screen.
The TV is ready to preset automatically all local channels for you.
If the TV is being used with a VCR, turn on the VCR and play
back a pre-recorded tape. The signal from the RF terminal of
your VCR is assigned to a TV channel.
6.
Now, press any button on the TV remote control to start Auto
Channel Preset.
The TV will go through the following steps automatically and
sequentially:
Automatic Channel Sorting System (ACSS): The TV set SEARCHES
FOR FREQUENCIES, memorises the channels found, and sorts them
(according to technical criteria) from Pr-01 of the TV, to a maximum
of 99 programmes.
This tuning process may take several minutes to perform.
Note:
If you need to repeat the "AUTO INSTALLATION", go on to
the section entitled -TV Channel Setting- (page 29).
Editing: When the TV has finished the automatic search, the «Stored
programmes» menu will appears on the screen. In this menu, you can
change the order of the channels and change or give the channels a
four-letter name.
On next page is a detailed explanation of editing options about
«Stored programmes» menu.
«AUTO INSTALLATION»
Searching
01 %
11
Power Indicator
Main power button
SHARP
AUTOINSTALLATION
Be sure the antenna cable is
connected...
Press any button on
the handset to start.
VCR
VÍDEO
Pr 01
Searching
please wait
Advertisement
Table of Contents
