Advertisement
OneRemote operation in a B&O system
To be able to operate the device correctly with the Beo4 the user has to be familiar with
operations with the original remote control as described in the device's user manual.
The beo4 remote control is not equipped with many keys, so we have designed a 'layout'
that works logically, even when shifting between different devices. To get a universal
layout for different devices, we needed to redefine a few of the beo4 buttons to other
functions:
Coloured buttons.
To make room for important functions, we have moved the coloured buttons, to a
lower layer. To send a 'red' button command
button. The same goes with the other 3 coloured buttons. This way we have freed
the direct function of the coloured buttons, to important operations.
In a OneRemote environment the red button is used as Back, Backup or return.
The green button is used as EPG, Guide or similar. Finally the blue and yellow
button is used for programme stepping.
Programme stepping, up/ down manoeuvring in menus.
Most set top boxes or TV's has 4 arrow buttons for moving up, down, left and
right in on screen menus. In addition they have separate programme stepping
buttons for zapping through programmes. B&O remote control does not have
separate buttons for programme zapping and menu manoeuvring.
We therefore have chosen the direct blue and yellow buttons to be used as
programme stepping buttons. The four up, down, left and right buttons have been
assigned for manoeuvring in on screen menus, in our basic setup.
It is possible to use the up and down arrow for programme stepping.
See page 6 about option programming.
Go or Record shifted operation.
Some of the buttons has been assigned 2 or three functions. To get to these they
have to be preceded with O or
Buttons that has been assigned secondary functions on this controller can be seen
in the operating table on page 2.
O
must be pressed before the red
q
.
Advertisement
