Table of Contents
Advertisement
DRIVER SUPPORT
||
WARNING
When driver support follows another vehi-
cle at speeds over approx. 30 km/h
(20 mph) and changes target vehicle –
from a moving vehicle to a stationary one –
driver support will ignore the stationary
vehicle and instead accelerate to the stored
speed.
The driver must then intervene and
•
apply the brakes.
Automatic standby mode when switching
targets
Driver support disengages and goes into
standby mode if:
your vehicle's speed goes under 5 km/h
•
(3 mph) and driver support cannot deter-
mine if the target vehicle is stationary or if
it is another object, e.g. a speed bump.
your vehicle's speed goes under 5 km/h
•
(3 mph) and the vehicle ahead turns so
that driver support no longer has a vehicle
to follow.
Related information
Driver support systems (p. 270)
•
Adaptive Cruise Control* (p. 280)
•
Pilot Assist* (p. 289)
•
300
Adjusting set speed for driver
support
It is possible to adjust set speeds for the
Adaptive Cruise Control* and Pilot Assist*
functions.
: Increases the set speed.
: Reduces the set speed.
Set speed.
Change a set speed by pressing the
–
(1) or
(2) buttons briefly or by pressing
and holding them:
Brief press: Each press changes the
•
speed in +/- 5 km/h (+/- 5 mph) incre-
ments.
Press and hold: Release the button
•
when the set speed indicator (3) has
moved to the desired speed.
NOTE
For vehicles without Adaptive Cruise Con-
trol*, speed instead increases by +/- 1km/h
(+/- 1 mph) each time the button is
pressed.
The most recently set speed will be
•
stored.
If speed is increased by depressing the accel-
erator pedal while pressing the
on the steering wheel, the vehicle's speed
when the button is pressed will be stored as
the set speed.
Temporarily increasing speed using the accel-
erator pedal, e.g. when passing another vehi-
cle, will not affect the setting. The vehicle will
return to the set speed when the accelerator
pedal is released.
* Option/accessory.
(1) button
Advertisement
Table of Contents
