Getting To Know Your Appliance; Controls And Burners - Siemens iQ500 EC6A Series Instruction Manual

Getting to know your appliance

en
:
Warning – Risk of injuries!
Pans which are damaged, are not the right
■
size, hang over the edge of the hob or are
not positioned correctly can cause serious
injuries. Follow the advice and warnings
provided relating to the cooking pans.
Incorrect repairs are dangerous. Repairs
Risk of injury!
■
may only be carried out, and damaged
power and gas lines replaced, by an after-
sales engineer trained by us. If the
appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales
service.
If a control knob is too stiff to turn or it is
Risk of injury!
■
loose, it must not be used. Contact our
after-sales service immediately to have the
control knob repaired or replaced.
:
Warning – Risk of electric shock!
Do not clean the appliance using steam
cleaners.
6
*Getting to know your
appliance
Y ou can find your appliance and the burner powers in
G e t t i n g t o k n o w y o u r a p p l i a n c e
the model overview. ~ Page 2

Controls and burners

Each control knob is marked with the burner it controls.
You can use the control knobs to set the output
required in each case to various positions between the
maximum and the minimum settings. Never try to switch
directly from position 0 to position 1 or from position 1
to position 0.
Indicators
Burner controlled by control knob
¼
Switched-off burner
Ú
9 Highest power setting and electric ignition
1 Lowest power setting
For dual double-flame burners, the inner and outer
flames can be controlled separately. The available
power levels are as follows:
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.
Inner flame on low power.