Display Function Of Load Condition - Samsung RF23R6 Series Service Manual

4-1-3. Display function of Load condition

1) Display function of Load condition
①
If Fridge Key and CoolSelectZone Key are pressed simultaneously for 6 seconds, ALL ON/OFF will blink with 0.5interval
for 4 seconds.
②
If take the finger off from above keys and press Freezer Key, load condition mode will be started.
1) If Fridge Key and CoolSelectZone Key are pressed simultaneously for 6 seconds during normal operation,
the temperature setting display of fresh food and Fridge compartments will blink ALL ON/OFF with 0.5 for 4 seconds.
2) At this moment, If Freezer Key after Fridge Key and CoolSelectZone Key is pressed, load condition display mode will be returned with alarm.
At LED all on state, only load condition display will blink ON/OFF with 0.5 seconds interval.
3) Load condition display mode shows the load that micom signal is outputting. However, It means that micom signal is outputting, it
does not mean whether load is operating or not. That is to say that though load operation is displayed, load could not be operated by
actual load error or PCB relay error etc. (This function would be applied at A/S.)
4) Load condition display function will maintain for 30 seconds and then normal condition will be returned automatically.
5) Load condition display is as below. Only the load control LED will blink with 0.5interval in "Display LED"
①
①
CoolSelectZone
②
65
TROUBLESHOOTING