Stealth Cam STC-XV4 Instruction Manual page 14

TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE images. This
"
setting can be changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the
UP and DOWN arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is
on the appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes
= 00). If the TL Delay is greater than or equal to 1 min, then the PIR sensor will be active
between time-lapse photos.
TL START – 06:00PM (default): This setting is used to give the camera the start time for when to start the time* lapse
"
photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour the format it will
show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows to allow the setting to be changed
from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow key to move to the MM (minute)
setting and it will start to blink.Using the UP and DOWN arrows will allow the setting to be change from 00 to 59.
Again when this setting is on the appropriate minute, press the RIGHT arrow key to move to the AP (am/pm) setting
and it will start to blink. Using the UP and DOWN arrows will allow the setting to be changed from AM to PM.
"
TL STOP – 08:00AM (default): This setting is used to give the camera the stop time for when to end the time-
lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour
the format will be HH/MM. With the HH (hour) setting to blinking, use the UP and DOWN arrows to allow the
setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow key
to move to the MM (minute) setting and it will start to blink. U sing t he U P a nd DOWN arrows will
allow the setting to be change from 00 to 59. Again when this setting is on the appropriate minute, press the
RIGHT arrow key to move to the AP (am/pm) setting and it will start to blink. Using the UP and DOWN arrows will
allow the setting to be changed from AM to PM.
•
REDUCE BLUR – ADVANCED (default): This is used to determine if the camera should use the MATRIX Blur
reduction technology to dramatically reduce the blur effect resulting in clearer night time infrared shots.
(STANDARD) Minimizes blurring effect in images whlle retaining long* range night image capability.
(ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This setting my cause a slight
reduction in night time range and increased grain in the image. With this option blinking, pressing the UP or DOWN
arrow buttons will cause the camera to cycle between the two options of STANDARD or ADVANCED.
EXAMPLE: Data Stamping on the bottom portion of the picture indicates the camera took a picture in Time
Lapse (TL) mode.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
14
Page