Stealth Cam STC-XV4 Instruction Manual page 11

o PIR PHOTO (default) : In this mode the camera will take a designated amount of picture with a
designated t ime out when t he camera senses activity i n front of the unit. This mode i s available for both day
and night activities.
"
PHOTO RES – 8.0 MP (default) : This setting is used to determine the Megapixel resolution of each image taken
by the camera. With this option blinking, use the UP or DOWN a rrow k ey to move between the options of: 22MP, 16MP,
8MP or 4MP. The higher the resolution of an image the more space the file will take on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting is only active if
TL Delay is set to 1 min or greater. This setting can be changed between the numbers of 00min 05sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes setting to be
changed from 00 to 59. Once t his setting is on the appropriate minutes, press the RIGHT arrow key to
move to the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the seconds
setting to be changed from 00 to 59 (05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change b etween
EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD setting, or NEAR
FIELD that will only trigger on movement closest to the camera.
PIR AUTO ADJUST - ON (default): When this setting is ON, the camera will automatically adjust the PIR sensitivity
"
to keep the PIR range consistent at different temperatures.
"
REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should use the MATRIX
Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time infrared shots.
(STANDARD) Minimizes blurring effect in images while retaining long-range night image capability.
(ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This setting my cause a slight
reduction in night time range and increased grain in the image. With this
option blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle
between the two options of STANDARD or ADVANCED.
"
PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number of photos the camera will
take during its activation. This setting can be changed between 1 PHOTO up to 9 PHOTOS. With this option
blinking, use the UP or DOWN arrow key to move between the value range in increments of 1.
IR BRIGHTNESS CONTROL – FULL (default): This setting is used to adjust the brightness of the IR LEDS. With this
"
option blinking, use the UP or DOWN arrow key to move between FULL and HALF brightness. On FULL brightness
the LEDs have a further flash range making it ideal for large open areas. HALF brightness is ideal for close up shots
preventing the subject from being overexposed.
SMART IR - ON (default): This setting is used to to toggle Smart IR ON and OFF. With this option blinking, use the
"
UP or DOWN arrow to move between ON and OFF. While enabled the camera will take color images during the
dusk and dawn lighting conditions. While Smart IR is ON, Photo Burst is limited to (1) image per triggering.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
11
Page