Analog Input (Ai 0 And Ai 1) - National Instruments NI 5772R User Manual And Specifications

Nominal values (or supplemental information) describe additional information about the
product that may be useful, including expected performance that is not covered under
Specifications or Typical values. Nominal values are not covered by warranty.
Related Information
Front Panel and Connector Pinouts

Analog Input (AI 0 and AI 1)

General Characteristics
Number of channels ............................................................................
Connector type ............................................................................
Input type ............................................................................
3
Input impedance ............................................................................
Input coupling ............................................................................
Digital data resolution ............................................................................
ADC part number ............................................................................
Absolute maximum voltage ............................................................................
Typical Specifications
All specifications were tested in TIS Disabled mode unless otherwise specified.
DC offset
AC-coupled ....................................................................
.................................................................... DC-coupled
............................................................................ Full-scale input
Gain error
AC-coupled ....................................................................
DC-coupled ....................................................................
3
Refer to Figures 8 and 9 for analog input return loss and VSWR.
4
Data is accessed using an I16 data type (left-justified).
5
For additional information about the ADC within your device, use the listed part number to locate
the appropriate Texas Instruments data sheet at
6
Available in the AC-coupled version and in TIS Enabled, Non-Multiplexed sampling mode only.
on page 5
Two
SMA
Single-ended, simultaneously sampled or time-
interleaved sampled (TIS)
50 Ω, per connector
AC (-01L version); DC (-02L version)
12-bit, signed, binary data
ADC12D800RF
±10 VDC, +21 dBm (7.1 V
±4.3 mV
±6.5 mV
+10 dBm (2 V
±2.0% full scale range (FSR)
±6.5% full scale range (FSR)
www.ti.com
NI 5772R User Manual and Specifications | © National Instruments | 19
4
5
)
pk-pk
) or +16 dBm (4 V
pk-pk
.
6
)
pk-pk