LG F1681TD Owner's Manual page 10

I nstallation
Type-C : Connecting one touch type hose to tap without thread
Ring plate
Guide plate
▶ ▶
Step3 : Connect hose to washer
After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square
or too big, remove the spacing ring before inserting the faucet into the adaptor.
Horizontal tap
10
Latch plate
Use the horizontal tap
Extension tap
1. Unscrew the adapter ring plate and
the 4 adapter retaining screws.
2. Remove the guide plate if the tap is
too large to fit the adapter.
3. Push the adapter onto the end of
the tap so that the rubber seal forms
a watertight connection.
Tighten the adapter ring plate and
the 4 screws.
4. Pull the connector latch plate down,
push the inlet hose onto the adapter,
and release the connector latch plate.
Make sure the adapter locks into place.
After connecting hose to water
tap, turn on the water taps to
remove foreign substances in the
water hoses. Remove dirt, sand
and sawdust remaining in the tap
pipes or water hoses, let water
drain into a bucket, and check the
water temperature.
• Make sure that there are no kinks in the
hose and that they are not crushed.
Square tap