Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Side cover
System board
Heat sink
WLAN card
M.2 2230/2280 Solid-state drive
Internal Antenna
Major components of OptiPlex 7000 Micro
The following image shows the major components of OptiPlex 7000 Micro.
Screw type
Quantity
#6-32 (Captive screws)
1
M3x5
5
M3x4L
3
M3x25 (Captive screws)
3
M2x3.5
1
M2x3.5
2
3
M3x3MM
Removing and installing components
2
Image
9
- Quick Links:
- Major Components of Optiplex 7000 Micro
Hide quick links:
Advertisement
Table of Contents
