Ricoh MD-P1 Service Manual page 156

4. Appendix: SP Mode Tables
1st Menu
Service Mode
[-15 to +15/ 1 step]
This adjusts the transfer roller current, based on the default value.
The range of adjustment is from -15 [μA] to +15 [μA], in units of 1.
The printer will warm up automatically after this setting is changed.
4
1st Menu
Service Mode
[0 to -30/ 1 step]
This adjusts the offset temperature of the fusing unit, based on the default value. The range of adjustment
is from -30 [°C] to 0[°C], the unit is 2.
The printer will warm up automatically after this setting is changed. *2
1st Menu
Service Mode
5th Menu
• Vertical
• Horizontal
[-15 to +15/ 0.33 mm/ 1 step]
This adjusts the vertical and horizontal registration for each tray.
If the machine settings are reset to the factory defaults, this value does not change.
Clear Log (2nd Menu)
This resets all log data.
56
2nd Menu
Engine Maintenance 2nd Transfer
2nd Menu
Engine Maintenance 2nd Transfer
2nd Menu
Engine Maintenance Registration
3rd Menu 4th Menu
Front
Back
3rd Menu 4th Menu
Fuser Temp
3rd Menu 4th Menu
Tray 1
Tray 2
By-pass
Duplex