Installation - Scotsman AF300 User Manual

AF300

Installation:

Water
The water supply for this ice machine has been in
contact with many materials since it fell from the
sky as rain. All rain is slightly acidic, and tends to
dissolve the materials it comes in contact with.
During water's journey to the ice machine, it has
flowed over and through the ground, been picked
up by a municipal or private pump, forced through
a series of pipes of differing construction and may
have been treated by the municipality providing
the water.
The water supplied to this ice machine will then
contain a variety of substances that will likely show
up as solids during the ice making process. These
solids are similar to those found when water is
boiled out of a saucepan. Only the water boils
away, and the minerals that were in the water
solidify in the pan. During ice making the water is
frozen into ice, and many of the minerals stay
behind in the ice machine water system. After time
the minerals will have to be dissolved by ice
machine cleaner, then flushed away during the
cleaning process.
An ice machine is a food manufacturing plant; it
takes a raw material, in this case water, and
transforms it into a food product, ice. The purity of
the water is very important in obtaining pure ice
and in maximizing product life.
The water to the ice machine should be filtered.
Water filters vary greatly in ability and function.
Install one that filters out suspended solids to a
dimension of 5 microns or less. The finer the filter
the better, but finer filters may plug-up sooner than
course ones. It may be necessary to add a course
filter ahead of the fine filter to prolong filter life.
Have the water tested. Either acidic water or
alkaline water will cause corrosion. Dissolved
solids cannot be filtered out. Check with a water
treatment specialist regarding testing, treatment
and filters.
This ice machine may be installed in the open or
under a counter. No clearance is required at the
sides or top beyond what's needed to place the
cabinet into position. Air cooled models blow air in
and out through the grills at the front. Space is
required for utility connections at the back.
The ice machine is not designed for outdoor
use. It must be installed indoors, in a
controlled environment. The air and water
temperatures must not exceed rated limits.
Electrical power is supplied through a cord
connected to the unit. All local codes must be
followed.
Pre-installation:
1. Inspect the place where the ice machine is to be
installed. Check for:
space for the cabinet
water supply,
drain availability
and electrical power supply.
No extension cords are allowed. The building drain
inlet must be lower than the drain outlet(s) at the
back of the ice machine. The water supply must
have a hand shut off valve accessible when the
unit is installed.
2. Determine the method of installation, is the
machine to be installed under the counter? Is the
drain in the floor under the machine? Is the water
inlet accessible from the top?
January 1993
Page 4