Installation; Product Confirmation; Transporting The Air Compressor - Sullair SRL-7.5MB User Manual

02250236-267 R02

Installation

1 Product Confirmation

1. Check the air compressor nameplate to verify that
the proper model air compressor was delivered.
2. Verify that there has been no damage to the air
compressor during transportation.
3. Verify that the items shown below are included
with the air compressor.
Rubber
User
vibration
Manual
sheets for
installation -
1 copy
4 Sheets
USER MANUAL
Oil Free Scroll Compressor
SRL-7.5MB, SRL-11MB, SRL-16.5MB
10 – 22 hp (7.5 – 16.5 kW)
SAFETY WARNING WARRANTY NOTICE
U s e r s a r e r e q u i r e d t o r e a d Failure to follow the instructions
the entire User Manual before and procedures in this manual,
handling or using the product. or misuse of this equipment, will
Keep the User Manual in a safe void its warranty.
place for future reference.
Subject to EAR, ECCN EAR99 and related export control restrictions.

2 Transporting the Air Compressor

Transporting the Air Compressor
Moving with a Forklift
P l a c e a b u f f e r p l a t e
between the air compressor
and the forklift to protect
the air compressor panels.
D o n o t t i l t t h e f o r k s o f
the forklift too much. Too
much tilt may cause the air
compressor to drop.
【Reference 】
● After installing the air compressor,
attach the plates shown in the figure
to the right.
These plates are shipped with the
compressor and will greatly reduce
compressor noise during operation.
● It is recommended that properly trained personnel move the air compressor.
● Operation of the air compressor with the transport fixtures installed will lead to excessive vibration
of the air compressor and the package may rupture. The transport fixtures must be removed prior
to operation of the air compressor.
4 - Steel
plates
＆ 8 - Bolts
PART NUMBER:
02250236-267 R01
publication date and applies to compressor models The information in this manual is current as of its
indicated on this cover until next revision of this manual
or release of a replacement manual.
Publication date: 04/01/2018
Copyright © 2017 – 2018 Sullair, LLC. All rights reserved.
Subject to EAR, ECCN EAR99 and related export control restrictions.
Model Nameplate
● Review the model
number, serial number,
power requirements and
compressor
specifications.
CAUTION
● Do not use an air compressor with
a power supply differing from the
specified power requirement.
Incorrect power supply may cause
a thermal event and/or abnormal
vibration.
Removing the Transport Fixtures
Remove the transport fixtures
● Open the front door, remove the yellow bolts and
remove the transport fixtures prior to operation.
Transport Fixtures Location
7.7/11kW : 2 locations
16.5kW : 3 locations
WARNING
4
Bolt
Fixture