5
5 V
0.9 A (USB IN) /
•
Used for HW Calibrator (Optional Accessory) connection.
•
Connect peripheral device to the USB input port.
•
A keyboard, mouse, or USB storage device can be connected.
•
To use USB 3.0, connect the A-B type USB 3.0 cable to the PC.
CAUTION
Cautions When Using a USB Storage Device
•
A USB storage device which has a built-in automatic recognition program or uses its own driver
might not be recognizable.
•
Some USB storage devices may not be supported or may not work properly.
•
It is recommended to use a USB hub or hard disk drive with power supplied. (If the power supplied
is not enough, the USB device may not be detected properly.)
6
•
Connect the RS-232C terminal with an external device to control the monitor.
7
•
This USB port is used only for service.
(USB UP)
8
•
Connects the power cord.
Potential Equalization Conductor
9
•
Connect an equipotential plug.
NOTE
•
All signal out terminals (SDI, DVI, etc.) output a signal when the power switch of the monitor is on. When the
power switch is off, no signal is outputted.
•
This monitor supports the
*
: A feature that allows you to add a device to your computer without the need for physical
device configuration or user intervention.
feature.
11