Table of Contents
Advertisement
2nd
3rd
DisplayPort Ver.
Input Port Ver.
Description
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the product (in
DisplayPort
mode) is displaying the message
to display the Function Key Guide screen and then select
only.),
1.2
(S28AG70*, S49AG95*N model only.) or
― If setting the
DisplayPort Ver.
to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual maximum output refreshing rate of the graphics
cards cannot achieve the level of 120 Hz/144 Hz.
― If the PC has entered BIOS mode and the BIOS screen does not appear, go to the following path and then select the mode.
→ 1.1,
1.2↑
(S27AG50*, S32AG50*, S27AG52*, S32AG52* model only.),
Select an HDMI version.
― S27AG50*, S32AG50*, S27AG52*, S32AG52*:
― S28AG70*:
1.4
/
2.0
/
2.1
― S49AG95*N:
1.4
/
2.0↑
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If the
HDMI Mode
is set to
2.0
(S28AG70* model only.), HDR On is available only in UHD 60 Hz. In a higher resolution (UHD 120/140), HDR On is unavailable
due to the bandwidth limitation.
― If you set the
HDMI Mode
to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― If you set the
HDMI Mode
to
2.0
(S28AG70* model only.), some high resolutions may not be supported because of bandwidth limitation of the HDMI 2.0
protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
― Set
HDMI Mode
to
1.4
if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
― Set
HDMI Mode
to
2.0
(S28AG70* model only.) if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays
a blank screen, or does not play sound at all.
Check the cable connection and the settings of the source device.
→
System
→
DisplayPort Ver.
→ 1.1,
1.4
(S28AG70*, S49AG95*N model only.).
1.2
(S28AG70*, S49AG95*N model only.) or
1.4
/
2.0
press the JOG button
1.2↑
(S27AG50*, S32AG50*, S27AG52*, S32AG52* model
→
System
→
DisplayPort Ver.
1.4
(S28AG70*, S49AG95*N model only.).
40
Advertisement
Table of Contents
