Table of Contents
Advertisement
S49AG95*N
x 4
3
Remove the COVER STAND BODY REAR
by pulling it in the direction as shown
in the figure.
7
Disassemble the COVER-REAR TOP. Assemble the COVER-REAR TOP to the stand
neck as shown in the figure. Rotate the COVER-REAR TOP clockwise.
11
Remove the package.
4
Insert the stand base into the stand
neck in the direction as shown in the
figure.
12
Move the product onto the table. At this time, hold the cables together not to be
stuck under the stand.
1
Connect the corresponding cables.
5
Place the stand neck on the monitor as
shown in the figure.
8
Place the corresponding cables into
the stand-neck holder. Do not stretch
the cable. Three cables in one holder is
recommended.
2
Collect cables and then align them with the centre groove of COVER REAR SUB.
Assembly the COVER REAR SUB on the rear of the product.
6
Fasten the screws at the top of the
stand neck.
9
Push the COVER STAND BODY REAR in
the direction as shown in the figure.
Caution
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
10
Stand up the monitor as shown in the
figure.
11
Advertisement
Table of Contents
