Advertisement
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS:
• 1/2" Box / Open End Wrench........................
• 3/8" Box / Open End Wrench........................
• 5/16" Box / Open End Wrench......................
GENERAL NOTES:
•
Unless otherwise noted Loctite 242/243 or equivalent thread locker must be used on all threaded fasteners. (Do not use
thread locker when a Nyloc nut is used.)
•
All NAUTILUS Strength equipment MUST be secured to the floor using either 10mm or 3/8in. (grade 5 minimum) bolts.
•
This Installation Instructions Manual must be used in conjunction with the equipment's Owner's Manual. The Owner's
manual describes equipment setup and instructs members on how to use it correctly and safely.
•
The Half Rack requires at least two people to perform the installation.
Should any component not be present or if you have any operational questions, please refer to your owner's manual or on the
web @ www.nautilus.com. Specifically refer to your serial number and model number labeled on your equipment.
PACKAGING REMOVAL:
Carefully remove all packaging materials that wrap the equipment. DO NOT USE A KNIFE OR BOX
CUTTER AS YOU MAY DAMAGE THE EQUIPMENT. At this time remove any sub-components from
the pallet and set aside for later assembly.
QTY
• Hex Key 5/16"................................
2
• Hex Key 7/32"................................
2
• Hex Key 3/16"................................
2
Page 8
QTY
2
2
2
Advertisement
