Table of Contents
Advertisement
Additional Items For Purchase
The following items are REQUIRED to complete
the installation:
CONTROL BOX MOUNTING HARDWARE
• Mounting to Wood:
Four #8 x 1-1/2" wood screws
• Mounting to Brick/Cement/Masonry:
Four 1/4" masonry screws 1-3/4" long
• Mounting to Metal:
Four #10-32 machine screws with washers and
lock nuts
GATE BRACKET MOUNTING HARDWARE
For 1 or 2 inch circular or square tubular constructed gates, use
the following U-bolts with associated fl at washers and hex nuts:
• 1" use 5/16-18 x 2-3/16" U-bolt (2)
• 2" use 5/16-18 x 3-3/16" U-bolt (2)
To secure the bracket to the gate, use the following hardware:
1/4-20 x 3" hex head bolt with associated fl at washers, lock
washers and hex nuts (2).
For gates with fl at mounting surfaces and a maximum thickness
2", an alternate to using U-bolts would be: 5/16-18 x 3" hex
head bolt with associated fl at washers, lock washers and
hex head nuts (4).
For chain link fences or other types with circular rails, it is best
to attach a vertical support panel connecting the top rail to the
bottom rail. The gate bracket can then be mounted to this vertical
panel using the same bolts, washers and nuts as mentioned above.
POST BRACKET MOUNTING HARDWARE
Two 3/8-16 x 6" carriage bolts with fl at washers, lock washers and
lock nuts.
Tools Needed
During assembly, installation and adjustment of the operator,
instructions will call for tools as illustrated below.
Deep Well Sockets
and Wrench
1/2", 5/8", 7/16", 9/16"
and 1/4"
Carpenter's Level
Screwdriver
Introduction
Drill Bits
1/2", 3/16", 5/16"
Drill
and 5/32"
Adjustable End Wrench
Phillips Head Screwdriver
Hammer
THE PROTECTOR SYSTEM
Two pair of UL listed, outdoor, infrared safety sensors.
• LiftMaster Model 50-220
See page 25 for more information.
Distance from indoor AC Outlet to
Control Box
100 ft. (30.5 m) or less
100 - 150 ft. (30.5 - 45.7 m)
150 - 250 ft. (45.7 - 76.2 m)
250 ft. (76.2 m) and above
* UL Listed, Stranded, Direct Burial, UV Resistant Wire Installed
per the National Electric Code, NEC.
WARNING: This product can expose you to chemicals
including lead, which are known to the State of California to
cause cancer or birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov
Clamps
Tape Measure
Wire Strippers (Optional)
4
SAFETY SENSORS
®
Wire Gauge Needed
16 gauge
14 gauge*
12 gauge*
Not Recommended
Welder (Optional)
Pencil
Wire Cutters (Optional)
Advertisement
Table of Contents
