Advertisement
Technical Information / Données techniques / Datos tecnicos
Input
Impedence
Frequency response
Sensitivity
Ambient temperature
Installation Considerations
•
For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
technician.
It is the responsibility of the installer
to know and follow all applicable
local codes and safety practices
when installing this product.
•
Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
•
This speaker is for indoor use only. It may be
installed in a shower or tub area.
•
Do not install the speaker where it may be
submerged in water.
•
Excessive use of the speaker is considered a
non-intended use, and is not covered under the
warranty.
Alimentation électrique
Impédence nominale
Réponse de fréquence
Sensibilité
Tempérenture ambiante
Potencía
Impedancia nominal
Repuesta de frecuencia
Sensibilidad
Temperatura ambiental
•
This speaker must be installed with Axor Starck
Basic Set 40876180 (not included).
•
The speaker is connected to the audio source using
1 AWG (.5 mm² or greater) speaker wire (not
included).
•
The installation surface must be even. If the surface
is rough or uneven, it must be made even using
silicone. If this is not done, the unit cannot seal
properly against moisture.
•
Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Caution! Loud noises can damage
hearing.
30 W RMS
8 Ω
75 Hz - 0 kHz
80 dB @ 1W/1m
105° F (40°C) max.
Advertisement
