Connecting To Computer - Sanyo PLV-70 Owner's Manual

CONNECTING PROJECTOR
Cables used for connection
• VGA Cable (HDB 15 pin)
• DVI-Digital Cable (for Single Link T.M.D.S.)
• BNC Cable
• Control Cable for Serial Port
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Monitor Output
MAC Adapter
Set slide switches
BNC
according to chart
Cable
below.
COMPUTER IN ANALOG
MAC ADAPTER
Set switches as shown in table
below depending on RESOLU-
TION MODE that you want to
use before you turn on projec-
tor and computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
12

CONNECTING TO COMPUTER

( = Cable or adapter is not supplied with this projector.)
Desktop type
Monitor Output
DVI
Cable
VGA Cable
COMPUTER IN DIGITAL
INPUT 1
ANALOG DIGITAL(DVI-D)
R/C JACK
CONTROL PORT
RESET
AUDIO 1 AUDIO 2
G B R H/V V
VIDEO/Y Cb/Pb Cr/Pr
INPUT 2
S–VIDEO
VIDEO/Y Cb/Pb Cr/Pr
R–AUDIO–L
(MONO)
INPUT 3
ON
ON DIP
1 2 3 4 5 6
OFF
1 2 3 4 5 6
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON OFF OFF
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cable {Mini Plug (stereo) x 1}
Laptop type
Serial port
Audio Output
Control Cable
Audio
for Serial Port
Cable
(stereo)
Terminal
COMPUTER
AUDIO IN 1 or 2
Terminals
of a Projector
NOTE :
When connecting cable, power cords of both
a projector and external equipment should
be disconnected from AC outlet. Turn a
projector and peripheral equipment on
before computer is switched on.
CONTROL
PORT