Table of Contents
Advertisement
Turn off power and restart the reader
6.2.2 Configure through LAN interface
Configure settings through LAN interface, if the IP address and the port number
of the reader are known. Make sure the IP address of the superior computer is
set into the same network as the reader.
- Configuration procedure is same as RS232C.
Connect the LP-ABR and the PC for setting with a LAN cable.
Start the terminal software "Configurator LP-ABR" in the host PC.
Specify the IP address / port number of this product as the connection point of
the terminal software.
The subsequent operation is the same as the setting from the RS-232C
connection.
† If the IP address of this product is in a different network, reconfigure the IP
address of the PC.
6.3
Default Settings
IP address
Sub net mask
Port number (only for reading result transmission)
Port number(only for image data transmission)
Default gateway address
: 192.168.209.10
: /24(same as 255.255.255.0)
: 27110
: 27110
: 192.168.209.254
70
Advertisement
Table of Contents
