Installing Your Appliance - Westinghouse WVEP615 User Manual

INSTALLING YOUR APPLIANCE

WARNING
WARNING
To avoid any potential hazard, you must follow our
instructions when you install your appliance. Failure
to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
• This appliance must be installed by an authorised
person according to all codes and regulations as
stated in the local municipal building code and other
relevant statutory regulations.
• Wiring connections must be in accordance with AS/
NZS 3000 Wiring Rules and any particular conditions
of the local authority.
• Refer to data plate for rating information. The data
plate is positioned behind the bottom of the oven
door.
• Disconnection in the fixed wiring must occur in
accordance with the AS/NZS3000 wiring rules.
• Wiring should be protected against mechanical
failure. Refer to AS/NZS3000.
• A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
• This range must be connected with cable of 75°C
rating minimum.
• This product has passed the insulation resistance test
after manufacture. If the resistance reading is low at
installation, it is probably caused by moisture from
the atmosphere being absorbed by the elements
after the range has been produced. (Pass at 0.01MΩ
AS/NZS 3000 Wiring Rules.
Rated power input
MODEL TOTAL kW
WVE645 8.7
PRODUCT DIMENSIONS
MODEL
(H X W X D) MM
WVE612 597 x 596 x 569
WVES613 597 x 596 x 569
WVE614 597 x 596 x 569
WVE615 597 x 596 x 569
WVE616 597 x 596 x 569
WVEP615 597 x 596 x 573
WVE617 597 x 596 x 569
WVEP617 597 x 596 x 573
WVEP618 597 x 596 x 573
WVE625 890 x 596 x 569
WVE636 1083 x 596 x 569
WVE645 597 x 596 x 569
WVE655 727 x 596 x 569
WVE665 890 x 596 x 569
WVEP627 890 x 596 x 573
Note: Electrical connection is 230-240 volts AC 50Hz. Wiring minimum temperature rating 75°C.
A1 kW A2 kW
2.3 6.4
MIN FUSE
RATING
16A
16A
16A
16A
16A
16A
16A
16A
16A
25A
32A
40A
25A
25A
25A
WARNING
WARNING
This appliance must be properly earthed.
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to secure
your oven into the cupboard. Use just 2 screws for
underbench and separate grill underbench ovens, and
4 screws for separate grill wall ovens. Remove the
bottom door in separate grill wall ovens to provide
access to the bottom 2 screwing points.
• For appliances fitted with a flexible supply cord, if
the cord is damaged, it must be replaced by the
manufacturer or its service agent or similarly qualified
person in order to avoid a hazard. The plug must be
accessible after installation.
• Where the appliance is built into a cabinet, the
cabinet material must be capable of withstanding
70°C. Installation into low temperature tolerant
cabinetry (e.g. vinyl coated) may result in
deterioration of the low temperature coating by
discolouring or bubbling.
• If the appliance is installed adjacent to vinyl-wrapped
surfaces, use an installation kit available from the
vinyl-wrap supplier.
• Electrolux Home Products cannot accept
responsibility for damage caused by installation into
low temperature tolerant cabinets.
• After installation, test and ensure that the appliance
operates correctly before handing it over to the
customer. It is recommended that this product is not
installed in an unvented living space, particularly if
that space incorporates sleeping quarters.
MAX POWER MAX CURRENT
RATING RATING
2.3kW 9.6A
2.3kW 9.6A
2.3kW 9.6A
3.3kW 13.8A
3.0kW 12.7A
3.1kW 12.9A
3.3kW 13.8A
3.3kW 13.8A
3.1kW 12.9A
5.3kW 22.1A
6.2kW 25.8A
8.7kW 36.1A
4.9kW 20.4A
5.3kW 22.1A
5.3kW 22.1A
WIRE SECTION
(MM²)
2.5
2.5
2.5
2.5
2.5
2.5
2.5
2.5
2.5
4.0
6.0
6.0
4.0
4.0
4.0
INSTALLING YOUR APPLIANCE
5