power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on.
c) When battery pack is not in use, keep it away 11. Always hold the body handle and side handle of the from other metal objects, like paper clips, coins, power tool fi rmly. Otherwise the counterforce produced keys, nails, screws or other small metal objects, may result in inaccurate and even dangerous operation.
3. If you fi nd rust, foul odor, overheating, discolor, CAUTION ON LITHIUM-ION BATTERY deformation, and/or other irregularities when using the battery for the fi rst time, do not use and return it to your To extend the lifetime, the lithium-ion battery equips with the supplier or vendor.
○ It may not be possible to charge some USB devices, Hammering only function depending on the type of device. NAMES OF PARTS (Fig. 1 – Fig. 21) Rotation only function Rotation and hammering function Handle Latch (one side) Switch trigger Latch (both sides) Switching ON Pushing button...
SPECIFICATIONS The specifi cations of this machine are listed in the Table on page 16. Specifi cations are for when a dust extraction unit has been installed. When used with the dust extraction unit uninstalled, the specifi cations are the same as those for DH36DPC. NOTE ○...
Page 12
(2) Regarding the temperatures and charging time of the rechargeable battery The temperatures and charging time will become as shown in Table 2. Table 2 Charger UC18YSL3 Type of battery Li-ion Temperatures at which the -10°C – 50°C battery can be recharged Charging voltage 14.4 Multi volt...
● Possible causes of sudden overburdening MOUNTING AND OPERATION 1 Tool bit biting into material 2 Impact against nails, metal or other hard objects Action Figure Page 3 Tasks involving prying or any excess application of pressure, etc. Removing and inserting the Also, other causes include any combination of the battery aforementioned.
6. Cleaning of the battery installation compartment CAUTION After drilling concrete, if concrete dust has accumulated In the operation and maintenance of power tools, the on the terminals or the area where the battery slides safety regulations and standards prescribed in each within the battery installation compartment, clean off...
Page 15
2. Charger Symptom Possible cause Remedy The charge indicator lamp The battery is not inserted all the way. Insert the battery fi rmly. rapidly fl ickers purple, and There is foreign matter in the battery Remove the foreign matter. battery charging doesn’t terminal or where the battery is attached.
Page 16
DH36DPC DH36DPD 36 V 0 – 1100 /min 0 – 4300 /min 28 mm 20 mm φ max 13 mm – φ max 32 mm – φ max 4.2 kg 6.1 kg ※ – DH36DPC (NN) – – – – –...