Table of Contents
Advertisement
Pairing the Wireless Subwoofer with the Soundbar
Automatic Pairing
Plug the soundbar and the subwoofer into the mains sockets and then touch
on the remote control to switch the unit to ON mode. The subwoofer and
unit or press
soundbar will automatically pair within 30 seconds.
When the subwoofer is pairing with the soundbar, the Pair indicator on the subwoofer
•
will fl ash rapidly.
When the subwoofer is paired with the soundbar, the Pair indicator on the subwoofer
•
will light up steadily.
During Standby mode, the subwoofer Pair indicator on the subwoofer will blink slowly.
•
Touch
on the unit or press
Do not press Pair on the rear of the subwoofer, except for manual pairing.
Manual Pairing
It is very abnormal that the connection would fail, you should not attempt manual pairing in normal
usage.
If the automatic pairing fails, the Pair indicator on the subwoofer will keep fl ashing and the
word "CHECK SUBWOOFER" will show on the display. Ensure that all the cables are well
connected, the main unit is switched to ON mode and the Pair indicator on the subwoofer
is fl ashing. If it still doesn't work, pair the subwoofer with the soundbar manually.
1. Unplug both units from the mains sockets again, then plug them in again after 3
minutes.
2. Press and hold the Pair switch on the rear of the subwoofer for a few seconds, and then
touch
on the unit or press
indicator on the subwoofer will rapidly blink when pairing and will become solid when
successful.
• The subwoofer should be within 6 m of the soundbar in an open area (the closer the better).
• Remove any objects between the subwoofer and the soundbar.
• If the wireless connection fails again, check if there is a confl ict or strong interference (e.g.
interference from an electronic device) around the location. Remove these confl icts or strong
interferences and repeat the above procedures.
on the remote control to switch the unit ON.
on the remote control to switch the unit ON. The Pair
on the
17
Advertisement
Table of Contents
