Yamaha YFM700PF Owner's Manual page 33

comes on after the engine is started, the EPS sys-
tem may not be working correctly. When this oc-
curs, have a Yamaha dealer check the EPS
system.
The electrical circuit of the warning light can be
checked by turning the key to "
warning light does not come on, have a Yamaha
dealer check the electrical circuit.
TIP
 If the engine is stopped using the engine stop
switch and the key is in the "
the EPS warning light comes on to indicate that
the power assistance for the steering is not
functioning.
 If the steering load is too heavy (i.e., excessive
steering use when the ATV is traveling at a slow
speed), the power assist is reduced to protect
the EPS motor from overheating.
EBU30451
On-Command four-wheel-drive indicator " ",
On-Command differential gear lock
indicator " " and indicator light "DIFF. LOCK"
The On-Command four-wheel-drive indicator " "
comes on when the On-Command four-wheel-
drive switch is set to the "4WD" position.
The
indicator " " and the On-Command differential
gear lock indicator light "DIFF. LOCK" come on
when the On-Command differential gear lock
switch is set to the "LOCK" position.
" (on). If the
TIP
 Due to the synchronizing mechanism in the dif-
 When the On-Command differential gear lock
" (on) position,
4-4
On-Command differential
ferential gear case, the four-wheel-drive indica-
tor may not come on until the ATV starts
moving.
switch is set to "LOCK" or "4WD", the
indicator " " and the indicator light "DIFF.
LOCK" will flash until the differential gear is
completely locked or unlocked. If the indicator
and the indicator light continue to flash, the dif-
ferential is not completely locked or unlocked.
In this case, start moving to allow time for the
differential to lock or unlock.
gear lock
4