Refrigerator Features; Reversible Doors - LG GA 489 Series Owner's Manual

REFRIGERATOR FEATURES

As a result of temperature-induced
deformations of refrigerator components, you
may hear a slight crackling noise. Sounds
typically heard when a thermal regulator or
compressor turns on are normal and may be
heard during the operation of any electrical
device.
The refrigerant circulating inside the
refrigeration system may produce a slight
gurgling sound, even if the compressor is off.
Do not worry, it is absolutely normal. During
refrigerator operation, you may hear:
- sound of compressor working;
- rustling of fans blades;
- sound of circulating air flow of cooling
system No Frost;
- relay operating clicks;
- buzzing of drive when opening and closing
damper;
- gurgling of refrigerant circulating through
pipes of refrigeration system;
- a slight crackling when materials deform
due to temperature changes.
These noises are not related to any defect
and have functional character.
ANTI-CONDENSATION PIPE:
• The anti-condensation pipe is located inside
the refrigerator body and around the front
side of the refrigerator to prevent
condensation.
• In these places, the refrigerator may heat
up, especially the first time it is turned on or
when the outside temperature is high.
Anti-condensation pipe
CARE AND MAINTENANCE

REVERSIBLE DOORS

The refrigerator is designed so that the doors
can open to the right or to the left depending
on how it fits into your kitchen.
NOTE
If you need to reverse the doors, you
should call a service technician. The
warranty does not cover door reversal.
REQUIRED TOOLS:
• 10 mm and 6 mm wrenches;
• 5 mm hex wrench;
• Crosstip screwdriver.
ATTENTION!
1. Before reversing the refrigerator doors,
unplug the device and remove the food
and all removable accessories like
shelves and drawers from the
refrigerator.
2. Do not lay the refrigerator down on the
floor.
3. Be careful to not drop the door while
disassembling and reassembling the
refrigerator.
• Remove the upper cover (2) of the
refrigerator compartment door by
removing the screws (1).
• Move the plug (3) to the opposite side of
the upper cover (2).
• Disconnect the connector cable (4).
• After removing the screws (5), pull it
forward and lift the cover without
damaging the wire (6).
• Remove the wire holder (7) and attach it to
the center of the cover (6).
• Install the plug (9) on the opposite side of
the cover (6).
(1)
(1)
(3)
21
(2)
(4)