Table of Contents
Advertisement
INSTALLATION
12
CLIMATE CLASS
The climate class is indicated on the
refrigerator's specification label located inside
the refrigerator compartment. Do not use the
refrigerator at a temperature exceeding the
established limits. The climate class is
defined by the refrigerator's conditions of
use.
Designation
Class
Extended
SN
temperate
N
Temperate
ST
Subtropical
T
Tropical
INSTALLATION
• Install stoppers in the upper corners of the
refrigerator's rear wall, as shown in fig. 1.
Stoppers are included with the refrigerator.
• The refrigerator is not a built-in. At the
sides, in the back, and at the top of the
refrigerator, there should be empty space of
no less than 5 cm so that air may circulate
and reduce electricity usage.
• Do not install the refrigerator near a heat
source, where it may come in contact with
direct sunlight, or in an area of increased
humidity.
• Refrigerator is constantly operating device
that makes distinctive sounds (refer to
page 21 «Refrigerator features» section),
so it is undesirable to install refrigerator
in places for rest and sleep.
• Make sure that the voltage indicated in the
instructions is indeed that supplied by your
home.
Outside temperature
range, in °C
From +10 to +32
From +16 to +32
From +16 to +38
From +16 to +43
• When installing the refrigerator abutting a
wall, make sure enough space exists to
open the door more than 90 degrees to
permit removal of shelves and drawers.
• Do not remove the round stickers on the
back of the refrigerator. They are decorative
in function and cover up some mechanical
apertures.
• To prevent vibration, make sure the
refrigerator is installed evenly. If required,
adjust legs. The refrigerator should be
installed slightly angled toward the rear to
help the doors close easily. To turn the
adjustable legs, tip the refrigerator slightly.
In order to lift up the front side of the
refrigerator, rotate the adjustable legs
counter-clockwise (
clockwise (
).
• Before use, thoroughly clean the
refrigerator. Do not wash the silicone
grease applied on the door gasket and
front part of the refrigerator body from
the side of door hinges. Grease prevents
bend of the gasket when closing the door.
• Some models have a transparent protective
film on the front of the shelves (the metal
part); we recommend you remove them
before using the unit;
• Install the removable parts, like the ice tray,
etc. in the appropriate locations;
• Plug the power cord into the outlet. Do not
plug any other electrical devices into this
outlet;
This appliance is intended to be used in
household and similar applications such as:
• Staff kitchen areas in shops, offices and
other working environments.
• Farm houses and by clients in hotels,
motels and other residential type
environments.
• Bed and breakfast type environments.
• Catering and similar non-retail applications.
CONNECTION
Upon installing the refrigerator, allow it to
operate for 2-3 hours to achieve operating
temperature, and only then place fresh or
frozen foods inside of it. The refrigerator is
now ready for use. After unplugging the
refrigerator, do not turn it back on again for
at least 5 minutes.
), and to lower it,
Advertisement
Table of Contents
