Operating Mist Blower - Echo DM-4610 Operator's Manual

Straps
Cushion
back-plate
Throttle control
lever
Shutter control lever
Collar nut
Collar
Collar nut
Collar
70 cm
DM-4610

OPERATING MIST BLOWER

Chemical tank
Spark plug
Fuel tank
Carburettor
Starter handle
Volume adjuster
Nozzle
FILLING CHEMICAL TANK
• Close valve.
• Fill liquid chemical through filter into tank. Stir up after
filling to avoid chemical deposits at bottom of tank.
• Secure tank cap firmly to avoid air pressure leakage. If
not, it results in poor spraying.
NOTE
Be sure that valve is closed before starting engine.
ADJUSTING SPRAY PATTERN
The spray pattern can be adjusted from the straight
stream to an open spray by adjusting the position of
collar.
• Loosen collar nut and pull collar forward to obtain a
straight stream.
• Push collar backward to obtain a wide spray.
ADJUSTING SPRAY VOLUME
The spray volume can be adjusted by lining up the
number with mark as shown. The spraying volume is
prescribed as follows.
Setting number
Discharge volume
(L/min)
NOTE
• Keep nozzle at a distance of 70 cm far from plants
to prevent damage.
• Make job done before diluted chemical depositting
at the bottom of the chemical tank.
CLEANING CHEMICAL TANK
Chemical tank should be cleaned after each use.
1. Fill chemical tank with clear water and run engine.
2. Open valve to pour water out to clean internal parts
of misting device.
12
1 2 3 4
1.1 2.1 3.2 4.3