Table of Contents
Advertisement
Setting up your SmartBand 2
Preparing to use your SmartBand 2
For your SmartBand 2 to work properly, you must install the latest version of the
SmartBand 2 application on your iPhone, and then pair and connect your SmartBand
2 device with your iPhone using Bluetooth®.
To set up your SmartBand 2 using Bluetooth®
1
Make sure that your SmartBand 2 device is fully charged and turned on.
2
On your iPhone, make sure that you have installed and updated the SmartBand
2 application to the latest version.
3
On your iPhone, open SmartBand 2, then follow the on-screen instructions.
You may need to update the firmware of your SmartBand 2 after it's successfully paired with
your iPhone.
If you don't see the introduction screen, you can tap the SmartBand™ tab on your SmartBand
2 application for help regarding connecting your device.
Reconnecting the SmartBand 2
In cases where a connection gets lost, your SmartBand 2 automatically performs a
series of reconnection attempts. If auto-reconnection fails, you can use the power
key to manually force the accessory to try reconnecting with your iPhone.
To force the SmartBand 2 to try reconnecting
•
Briefly press the power key of your SmartBand 2 device, or tap Search for
SmartBand™ on the SmartBand™ tab of your SmartBand 2 application on
your iPhone.
If you still have issues connecting to your iPhone, tap the help button on the SmartBand™ tab
on your SmartBand 2 application and follow the on-screen instructions.
Resetting your SmartBand 2
Reset your SmartBand 2 if it behaves unexpectedly or if you want to connect it to a
new device.
To perform a factory reset
1
Turn off your SmartBand 2.
2
Press and hold down the power key for 5–10 seconds until a green light starts
flashing.
To unpair your SmartBand 2
1
On your iPhone, find and tap Settings > Bluetooth.
2
Find SWR12 and tap
3
Tap Forget Device to confirm.
This is an Internet version of this publication. © Print only for private use.
, and then tap Forget This Device.
7
Advertisement
Table of Contents
