General Installation - NEC MultiSync ME431 IR-2 User Manual

General Installation (1/2)

This device cannot be used or installed without a mounting accessory for support. For proper installation it is
strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard
mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation. Failure to follow these recommendations could result in
voiding the warranty
Mounting
For customer:
CAUTION
DO NOT mount the monitor yourself. For proper installation it is strongly recommended to use a trained,
qualified technician. Please contact your supplier, as they may be able to provide a list of qualified installation
professionals. Mounting on a wall or ceiling and hiring a technician is the customer's responsibility.
Maintenance
• Periodically check for looses screws, gaps, distortions, or other problems that may occur with the mounting
equipment. If a problem is detected, please refer to qualified personnel for service.
• Regularly check the mounting location for signs of damage or weakness that may occur over time.
DO NOT block ventilated openings with mounting accessories or other accessories.
For NEC Qualified Personnel:
Stability Hazard.
The device may fall, causing serious personal injury or death. To prevent injury, this device must be securely
attached to the floor/wall in accordance with the installation instructions. Carefully inspect the location where the
unit is to be mounted. Not all walls or ceilings are capable of supporting the weight of the unit. Weight of this
monitor is mentioned in Specification (ME431 IR-2, ME501 IR-2 & ME551 IR-2). Product warranty does not
cover damage caused by improper installation, remodeling, or natural disasters. Failure to comply with these
recommendations could result in voiding the warranty.
To ensure safe installation, use two or more brackets to mount the unit. Mount the unit to at least two points on
the installation location.
NOTE: To achieve optimum performance of touch technology, monitor must be correctly leveled. Only straight
upright and titled back position of the monitor is acceptable. Monitor tilted to front will result in convex position of
the glass and might negatively influence the touch performance.
For further instructions, please refer to standard user's manual of the base model monitor ME431,
ME501 & ME551.
Convex position
of glass
14