Samsung SNB-7000 User Manual page 54
Network camera
Hide thumbs
Also See for SNB-7000:
- Technical specifications (1 page) ,
- User manual (102 pages) ,
- User manual (114 pages)
Table of Contents
Advertisement
setup screen
To add a preset
1)
Select the preset number to add.
2)
Set the name for the preset.
3)
Press the [
To delete a preset
1)
Select the preset number to delete.
2)
Press the [
To move a preset
1)
Select a preset number that you want to move.
2)
Press the [
6.
Specify the serial port.
You can set the RS-485 communication mode for pan/tilt-compliant receiver that is
connected to the network camera.
•
Protocol : Select one from SAMSUNG-T/ SAMSUNG-E / PELCO-D/ PELCO-P/
SUNGJIN.
•
Camera ID : Provide a camera ID.
•
Baud rate : Transfer rate for RS-485 communications
•
Data : Specify the data bit.
•
Parity : Specify the parity bit.
•
Stop bit : Specify the stop bit.
M
All these operations above mentioned will be enabled only if the network camera is properly
connected to the pan/tilt-compliant receiver. And the serial port for the pan/tilt operations should
be properly specified.
J
The baud rate may not be controlled depending on the product specifications.
7.
When done, click [Apply (
54_ setup screen
] button.
] button.
] button.
)].
Advertisement
Table of Contents
