Advertisement
II. BATTERY INSTALLATION
Requires 3AA alkaline batteries for vehicle and 3 AAA
alkaline batteries for the transmitter. Batteries included are
for demonstration purposes.
Vehicle
1. Use a screwdriver (not included) to unscrew the battery
door screw, remove the battery cover.
2. Remove batteries included for demonstration purposes
and dispose of them safely. Install 3 new AA batteries
with polarity (+/-) as shown inside the battery
compartment.
3. Replace battery cover and tighten screw.
Transmitter
1. Use a screwdriver (not included) to unscrew the battery
door screw, remove the battery cover.
2. Install 3 new AAA batteries with polarity (+/-) as shown
inside the battery compartment.
3. Replace battery cover and tighten screw.
III. OPERATION
Infrared LED in Transmitter needs to point towards vehicle
during playing. If the vehicle doesn't respond well when a
button in transmitter is pressed, control the transmitter to
point toward vehicle again.
q
Forward / Lights
w
Reverse / Lights
e
Engine sounds / Lights
r
Speaker sounds / Lights
NOTE: Hold down this button few seconds to activate
speaker sounds and lights feature.
RESET button:
Press reset button when car seems can't get Infra-red
signal properly.
q
w
RESET button
e
3 x AA
3 x AAA
r
Advertisement
