Mattel DISNEY PIXAR THE WORLD OF CARS M5748 Instructions Manual

ADULT ASSEMBLY REQUIRED.
START HERE!
Follow the step-by-step instructions to set up your race set.
Please separate the "Assembly Map" page, and keep it handy during
assembly. This page contains the contents list and large-scale Layout
Drawings of the fully-assembled track. You'll need to refer to it as you go.
The Assembly Map looks like this:
6
1
1 1
F
6" STRAIGHT
9" TERMINAL TRACK
9" RADIUS CURVE
6
8
1 1
GUARDRAILS
VEHICLE
VEHICLE
MAIN LAYOUT DRAWING
Use either a diorama or a guardrail on the outside of the curves.
F
F
C
F
F S
1
A
1
F
F
1 = Beginner
2 = Average player
3 = Skilled player
Look for this symbol throughout this manual. It indicates important
information.
Be sure to check out the Troubleshooting Guide on the back of the
Assembly Map.
I. BASIC TRACK ASSEMBLY
Start out on a clean, hard, flat racing surface – not carpeting. Take out
all the track pieces (and other parts) and check them carefully against
the contents list on the Assembly Map.
for future reference, as they contain important information.
CAUTION: This toy contains a
functional sharp edge (tracks and
controller plugs) - for use under direct
supervision of an adult. Take extra
care during unpacking and use.
This page shows the contents list and large-scale Layout
Drawings of the fully-assembled track (tracks are not drawn to scale).
You'll need to refer to it as you assemble your race set.
Refer to the Instruction Sheet for detailed step-by-step instructions
for setting up and using your race set.
1
2
S
15" SQUEEZE
CONTROLLERS
BATTERY PACK
1
1
2
SANDPAPER
CLIPS
1
Refer to the package
#2 SUPPORTS
CARD BOARD
for color photographs
of the assembled layouts. ALTERNATE LAYOUT DRAWING
1
= TRACK SUPPORTS
Keep these instructions
1. There are letters molded into each
track piece. These letters are used
in these instructions to indicate
which track piece goes where.
Following the layout drawings on
the Assembly Map, you may want
to lay out your track – without
connecting any track pieces. That
way you'll be able to see how the
track layout goes together.
2. To connect track pieces: working on the flat surface, push the ends of the
track pieces together. Make sure they snap together securely – you'll hear
a click when they're properly connected.
Remember: if the track connections aren't right, electric power won't
flow from one track section to the next.
3. To disconnect track pieces,
simply reach underneath where the
track pieces meet and press the
locking tabs together with thumb
and forefinger as shown.
Occasionally the metal track rails will stick up too far from the
surface of a track piece, as shown. This may interfere with
vehicle movement. To correct, simply press the rail back down
with your finger. If the problem persists, please contact Customer
Service toll-free at 1-888-557-8926 (see hours of operation in the
Warranty section).
= GUARDRAILS
M5748-0921
Sometimes brand-new track may need a quick cleaning for best
performance. Check the Maintenance section of this manual for more
information.
II. DETAILED TRACK ASSEMBLY
a. Your race set makes two different layouts. Refer to the Assembly Map
for detailed track assembly. Start with the Terminal Track
continue adding track pieces until your
layout is complete.
b. Once your layout is assembled, you'll need
to add guardrails. Refer to the Assembly
Map for placement. To attach a guardrail:
gently flex the guardrail before attaching
it. Carefully attach the bottom of the
guardrail first. Then pull up and snap into
place. Don't force
guardrails into place.
INSTRUCTIONS
5+
M5748-0920
and