Westinghouse WVE6515SD User Manual page 21

Removing the side racks
1. Grasp the middle wire at the front.
2. Pull firmly inwards while pushing back.
Removing and replacing the oven back light and
side light (where fitted)
• Turn oven light glass anticlockwise to remove it for
globe replacement.
• To remove side light, place a spoon under the light
glass and lever off. Replace globe and snap glass
cover back into position.
• A special high temperature resistant globe should
be used. This can be purchased from Electrolux
Customer Care Centre.
NOTE: :Light globes are not covered by warranty
WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
ARNING
Releasing the grill element
WARNING
ARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
Retaining wire models - The upper grill element is secured
with a hanger clip which can be removed to help clean
the oven cavity ceiling. To remove the hanging clip push
the sides of the clip in the direction of the arrows. After
cleaning, raise the grill element and secure clip back
into position.
NOTE: Diagram shows a grill in oven model. The
procedure is the same for separate grill models which use
the same hanger clip in the grill compartment.
Rotating latch models - rotate latch 180 degrees and the
grill element will drop down freely. After cleaning, raise
the grill element and secure by rotating the latch back 180
degrees.
CARE AND CLEANING
21