Table of Contents
Advertisement
Figure 16. Installing the battery
Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
2. Replace the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Battery cable
Removing the battery cable
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
44
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
