Table of Contents
Advertisement
CARING FOR YOUR BREWER
CLEANING THE EXIT NEEDLE
1.
If a clog arises in the Exit Needle, push
the lever of the Pod Holder to reveal the
Exit Needle.
3.
After all the pieces are cleaned, place the
Base then the Pod Holder assembly into
the Brew Head. Lower the Handle.
2.
Use a paper clip or similar tool to
loosen the clog. Rinse thoroughly
with hot water.
Sharp needles.
Do not put fingers
in the chamber.
32
CLEANING THE SENSOR
Coffee grounds can become lodged by
the brewer's sensor, requiring cleaning.
Use a damp paper towel to get the
sensor cleaned in a few quick steps.
This maintenance should be conducted
once a month or whenever you notice
debris on the sensor.
2.
Locate the clear plastic sensor in the
Brew Head.
2 | TIPS & MAINTENANCE
1.
Lift the handle.
2.
With a damp paper towel, wipe all areas
of the sensor several times, being careful
to not leave fingerprints, water droplets,
or debris.
33
Advertisement
Table of Contents
