Chapter 2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung CL29A10 Owner's Instructions Manual

KS7A(ET)Latin_ENG 12/7/03
I
C h a p t e r Tw o N S TA L L AT I O N
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads," below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads," on page 15.
If you have two antennas, see "Separate
VHF and UHF Antennas," on page 15.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
14
4:53 PM Page 14
1
Place the wires from
the twin leads under
the screws on the 300-
75 ohm adaptor (not
supplied). Use a
screwdriver to tighten
the screws.
2
Plug the adaptor into
the VHF/UHF terminal
on the bottom of the
back panel.