Shark Steam Pocket Mop Owner's Manual page 4

Quick Start
1
3
ASSEMBLE
1 Insert the mop handle into the pump
actuator (the tube that leads to the tank).
Push the mop handle and pump actuator
together in until you hear it click into place.
2 Select a cleaning pad. Fit one side of the
pocket onto the head first, then using the
lavender loop, pull the pocket over the
head. Attach the quick fasteners on the top
of the pocket to secure in place.
3 Snap the mop head into the base to secure
it. Press the release button to exchange
mop heads.
TOLL FREE: 1-800-798-7398
When assembling your Steam Pocket
may be a little water in or around the water tank.
This is because we test all our Steam Pocket
Mops 100% before you buy them, so you get a
quality Shark Steam Pocket
®
2
4
FILL
4 Lay the mop on the floor or on a counter
top and remove the water tank cap by
turning counter clockwise. Fill the water
tank using the filling flask. Do not overfill
the water tank. Replace the water cap and
tighten.
IMPORTANT: Make sure your floors are
sealed. Before using the Steam Pocket
Mop consult page 4 for more information.
Mop there
®
®
Mop.
®
®