Toro Workman 07170 Installation Instructions Manual page 4

Installing the Lift Bracket
1. Remove the existing bolt and nut from the rear-frame tube (box A of
Note:
Discard the bolt and nut.
2. Remove the 2 existing plastic rivets from the rear-frame tube (box B of
Note:
Retain the 2 plastic rivets.
3. Install the lift bracket to the rear-frame tube using the 5 flange-head bolts (3/8 x 2-1/2 inches) and 5
flange nuts (3/8 inch) as shown in box C of
Torque the flange-head bolts (3/8 x 2-1/2 inches) to 37 to 45 N∙m (27 to 33 ft-lb).
4. Install the 2 previously removed plastic rivets into the rear frame tube (box D of
1x 5x
Figure
Figure 5
5x
Figure
Figure
5.
4
5).
5).
Figure 5).
g381446