LG DLEX2650 Series Owner's Manual page 41

BEFORE CALLING FOR SERVICE
Problem
Steam doesn't
generate but no error
code is shown
Garments still
wrinkled after
STEAM FRESH
There are no creases
left on garment after
STEAM FRESH
Garments have
static after REDUCE
STATIC
Garments are too
damp or too dry after
REDUCE STATIC
Garments are not
uniformly damp after
EASY IRON
Water drips from door
during Steam Cycle
Steam is not visible
during Steam Cycle
Drum does not turn
during Steam Cycle
Cannot see steam
vapor at the
beginning of cycle
The display shows
Odors remain in
clothing after
STEAM FRESH
CHECK FILTER light
is on during the
drying cycle
FLOW SENSE
indicator light is on
during the drying
cycle
MFL67408112_EN_111004.indd 41
Possible Causes
• Water level error.
• Too many or too different
types of garments in dryer.
™
• The function of this cycle
is to remove wrinkles from
™
fabric.
• This is normal.
• Correct drying options not
selected.
• Number of garments or load
size not properly selected at
the beginning of the cycle.
• This is normal.
• This is normal.
• This is normal.
• This is normal.
• MORE TIME button pressed.
• STEAM FRESH
remove odor completely.
™
• Lint filter is almost clogged
or full.
• Ductwork is too long or has
too many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup
or debris.
• The appliance has detected
a restriction in the external
dryer venting.
(cont.)
Solutions
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting
REDUCE STATIC option.
• Select the correct number or garments or load
size before starting the cycle.
• Condensation will normally form on the inside
of the dryer door during steam operation. Some
condensation may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is
closed. However, condensation will normally form
on the inside of the dryer door if the steam system
is operating normally.
• The drum is turned off so that the steam vapor
remains in the drum. The drum will normally turn
for about 2 seconds once a minute.
• Steam is released at different stages of the cycle
for each option.
• This display indicates that the steam option has
been set for a "
Press the LESS TIME button to reduce the
indicated load size.
did not • Fabrics containing strong odors should be
™
washed in a normal cycle.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the
Installation Instructions.
• D uctwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times
may be longer.
• If exhaust restrictions are sensed by the FLOW
SENSE system, the indicator will remain on for two
hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
" item such as a comforter.
41
2011.10.4 10:52:27