Table of Contents
Advertisement
To open the door proceed as follows:
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
10.13 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Start/Pauze.
In the display the door lock indicator
goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pauze.
The delay start continues.
10.14 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the door
locked indicator
The indicator of Start/Pauze button goes
off.
1. Press button Aan/Uit to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
goes off.
10.15 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pauze button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press Aan/Uit some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.16 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pauze
button.
Press the button Aan/Uit to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button Aan/Uit to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
ENGLISH
15
is on. The
goes
Advertisement
Table of Contents
