Table of Contents
Advertisement
Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
NOTICE ›
DO NOT remove the shipping bracket (glass
swing doors; fig. 2) until the appliance is installed in its final
location. Do not discard; use the bracket when next moving
the appliance.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the appliance. See fig. 4.
NOTICE ›
Move the appliance as close as possible to the
final location before removing the wooden skid. Some models
may require removing the front and/or rear grill/cover to access
the shipping bolts.
3. If leveling legs or castors will not be used, remove the
appliance from the wood skid and set the skid aside.
NOTICE ›
DO NOT lift the appliance by the counter tops,
doors, drawers, or grills.
If leveling legs or castors will be used, rotate the appliance
on the skid (see fig. 5) and see the installation instructions on
page 12.
Fig. 1. Remove the existing packaging.
TEC_TM 204 | REV. A | EN
MODEL SERIES
Fig. 2. Remove the glass swing door shipping bracket, if so equipped.
Do not discard.
Fig. 3. Shipping bolt locations.
Fig. 4. . When lifting the appliance, do not use countertops, doors/drawers, or grills
as a lifting point.
06/15/2023
truemfg.com
Page 11 of 28
Advertisement
Table of Contents
