Table of Contents
Advertisement
Steps
1. Slide the internal speaker module into the slot on the chassis.
2. Connect the internal speaker cable to the system board.
3. Route the cable through the routing guides on middle frame and connect the internal speaker cable to the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
CAUTION:
Removing the coin-cell battery resets the BIOS setup program's settings to default. It is
recommended that you note the BIOS setup program's settings before removing the coin-cell battery.
2. Remove the
side
cover.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
50
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
