For Your Safety - Panasonic VL-SV70 Installation Manual

For your safety

To prevent severe injury and loss of life/
property, read this section carefully
before using the product to ensure proper
and safe operation of your product.
WARNING
Preventing fire, electric shock and
short circuits
RLeave installation work to the
dealer. Installation work requires
technique and experiences. Failure
to observe this may cause fire,
electric shock, injury, or damage to
the product. Consult the dealer.
RElectrical connection work should
be performed by certified
personnel only. Certification is
required for performing electrical
connection work. Consult your
dealer.
RDo not attempt to disassemble or
modify this product. Contact an
authorised service centre for repairs.
RNever install wiring during a lightning
storm.
RDo not connect non-specified devices.
RDo not connect a power cable to a
terminal that is not specified in this
guide.
RWhen opening holes in walls for
installation or wiring, or when securing
the power cable, make sure you do not
damage existing wiring and ductwork.
RDo not make any wiring connections
when the power supply is turned on.
RDo not install the main monitor in the
following places:
2
– Places where the main monitor may
be splashed with water or chemicals.
– Places where there is a high
concentration of dust, or high
humidity.
RDo not place objects on the power
cables. Install the product where no
one can step or trip on the power
cables.
RDo not allow the power cables to be
excessively pulled, bent or placed
under heavy objects.
RWhen existing wires are used, it is
possible that they contain AC voltage.
Contact an authorised service centre.
CAUTION
Preventing electric shock
RIf the wiring is underground, do not
make any connections underground.
RIf the wiring is underground, use a
protection tube.
RIf the wiring is outdoors, use a
protection tube or a surge protector.
Preventing injury
RInstall the product securely adhering
to the instructions in this guide to
prevent it from falling off the wall.
Avoid installing onto low-strength
walls, such as gypsum board, ALC
(autoclaved lightweight concrete),
concrete block, or veneer (less than
18 mm thick) walls.
RTo prevent serious injuries due to the
product unexpectedly falling, the
product with a wall mount feature must
be installed at a height of 2 m or lower.