Test Data At A Glance - Sharp R-677W Service Manual

Microwave oven with top and bottom grill

Hide thumbs

Table of Contents

COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE

4. Hold the door panel to the door frame with four (4)

screws.

5. Catch two (2) pins of door panel on two (2) hole of upper

and lower oven hinges.

6. Re-install choke cover to door panel by pushing.

Note: After any service to the door;

(A) Make sure that door sensing switch and primary

latch switch are operating properly. (Refer to

chapter "Test Procedures".).

(B) An approved microwave survey meter should be

used to assure compliance with proper micro-

wave radiation emission limitation standards.

(Refer to Microwave Measurement Procedure.)

After any service, make sure of the following :

1. Door latch heads smoothly catch latch hook through

latch holes and that latch head goes through centre of

latch hole.

2. Deviation of door alignment from horizontal line of

cavity face plate is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity

face plate.

4. Check for microwave leakage around door with an

approved microwave survey meter. (Refer to Micro-

wave Measurement Procedure.)

Note: The door on a microwave oven is designed to act

as an electronic seal preventing the leakage of

microwave energy from oven cavity during cook

cycle. This function does not require that door be

air-tight, moisture (condensation)-tight or light-

PARTS

Special fuse

Fuse

Thermal cut-out (HVT)

Thermal cut-out (OVEN)

Grill heating element (top)

Bottom heating element

Oven lamp

High voltage capacitor

Magnetron

Power transformer

WARNING: DISCONNECT THE PLUG WHEN MEASURING RESISTANCE.